Difference between revisions of "Programming AVR micro-controllers"
From ShawnReevesWiki
Jump to navigationJump to search| Line 6: | Line 6: | ||
===Arduino as ISP=== | ===Arduino as ISP=== | ||
The Arduino community provides a simple way to use an existing Arduino to program a new AVR chip, at least to burn an Arduino bootloader onto it. An AVR on a breadboard, optionally with a crystal oscillator, is connected by four wires to an Arduino, which takes the program from the computer and programs it onto the AVR.<ref>http://arduino.cc/en/Tutorial/ArduinoISP</ref> | The Arduino community provides a simple way to use an existing Arduino to program a new AVR chip, at least to burn an Arduino bootloader onto it. An AVR on a breadboard, optionally with a crystal oscillator, is connected by four wires to an Arduino, which takes the program from the computer and programs it onto the AVR.<ref>http://arduino.cc/en/Tutorial/ArduinoISP</ref> | ||
| + | |||
| + | ==References== | ||
| + | <references /> | ||
[[Category:Electronics]] | [[Category:Electronics]] | ||
Revision as of 08:21, 19 March 2014
This document is intended to collect tips on programming AVR micro-controllers, such as Atmel's ATMEGA328P.
Developing programs
Lady Ada writes a tutorial for learning to program AVR micro-controllers, including setting up a CLI-based environment with gcc. [1]
Uploading programs
There are many ways to upload programs onto chips.
Arduino as ISP
The Arduino community provides a simple way to use an existing Arduino to program a new AVR chip, at least to burn an Arduino bootloader onto it. An AVR on a breadboard, optionally with a crystal oscillator, is connected by four wires to an Arduino, which takes the program from the computer and programs it onto the AVR.[2]
